lowering my 01?

[fromtheashes]

Hey everyone I know there was an old thread about lowering springs. But just curious how low you all think I can drop my 01 ssei before I start rubbing or anything along those lines.

[nos4blood70]

I think 2.25 is what all the people who have them, have done.

[fromtheashes]

Yeah I went to customsprings.com and got a quote for about 450 for front and back. Just looking at my wheel well and it doesnt look like there is much room. So I have to measure. But knowing what other people of done helps a lot.

[samples08]

I think 2.25 is what all the people who have them, have done.

Any idea what type of kits there using to achieve this?

[nos4blood70]

Custom made springs, from coilsprings.com I believe.

[Evilcowboy420]

I remember seeing someone just cut down their coil springs with and angle grinder. Not the same type car but the idea is the same. He took and inch off and went from there until he got what he wanted. I am not familiar with the SSEi setup but for the most part I would assume it would work the same unless there is something special to make this a no no.

If you go this route I would take 2 off to give myself room for error.

[yourgrandma]

The bonnevilles springs are all pigtailed so they can't be cut to lower the car.

[fromtheashes]

The quote I got from customsprings.com was 450 total front and rear, at -1.5 with a 25% increase in stiffness.

Does anyone know why they need my stock oem spring part number????

[yourgrandma]

So they can calibrate their height and rate off of that. It would save you a lot of headache to just ask for the same springs as one of us who has already gone back and forth a few times.

[fromtheashes]

So they can calibrate their height and rate off of that. It would save you a lot of headache to just ask for the same springs as one of us who has already gone back and forth a few times.

I followed you until the last part. Can you elaborate on that please.

[yourgrandma]

Several members have ordered custom springs from them. Most of the sets have been duplicates of the set I had made last year.

[fromtheashes]

Several members have ordered custom springs from them. Most of the sets have been duplicates of the set I had made last year.

What Struts did you upgrade with along with your springs?
KYB AGX Adjustables?

[yourgrandma]

I got the last known set of oem acdelco gxp struts. I haven't gotten around to nodding grand prix struts to fit bonnevilles but they never made agxs for the Bonneville.

[fromtheashes]

Dang so looks like I just gotta go OEM with the spring

[Zeik75]

So bout that last set.....last time i checked my dealership had 5 full fe5 gxp sets they could get shipped here.

[Zeik75]

Both struts and springs actually