Pontiac Bonneville Club Photo Gallery

Pontiac Bonneville Club online photo album

Image search results - "g"
004.jpg
 Peterg22000's 1992 SSEi608 viewsPeterg22000's 1992 SSEi
006.jpg
 Peterg22000's 1992 SSEi777 viewsPeterg22000's 1992 SSEi
013.jpg
 Peterg22000's 1992 SSEi649 viewsPeterg22000's 1992 SSEi
019.jpg
 Peterg22000's 1992 SSEi680 viewsPeterg22000's 1992 SSEi
01_Front_RH_Rust_40_percent.JPG
 Right hand corner rusted501 viewsThis is the right front corner of the car, right behind the wheel, with the front fender removed. The small tube sticking out is the sunroof drain. You can see I have just started to cut away the rusted areas with a cut off wheel.
04_Front_RH_Rust_under_2_40percent.JPG
 Looking Up at Floor470 viewsThis is looking up from underneath the car. You can see a hole right through to the interior.
06_Floor_Int_Prep_40percent.JPG
 Floor prepared445 viewsThis the floor, passenger side. I cut out as much as I could that was bad and then added metal from here.
09_RH_welded_40percent.JPG
 Right Hand corner all welded398 viewsThis shows the right front of the car after welding.
10498229_742726062450191_2692440150652796495_o.jpg
 Random Pic79 views Random Picture After A Nice Cleaning.
12_Floor_Partial_40percent.JPG
 Floor Partial Reconstruction453 viewsThis shows the reinforcement I added to the interior. I bolted and welded a heavy piece of metal right above the lift tab. My goal was to make it possible to jack the car at the lift point, and I was successful.
16_RH_corner_painted_40percent.JPG
 RH corner painted481 viewsThis is the RH corner after painting with POR-15.
17_Floor_Complete_40percent.JPG
 Floor complete417 viewsThis is the floor completed, it was painted with POR-15 and then sealed with 3M seam sealer. As a last step, I pop riveted a thin piece of sheet metal (shown) where your feet rest. It didn't need to be very strong, I just needed to fill in the hole.
137 files on 12 page(s) 12 3 4 5 6 7 8 9 10 11 12