Page 1 of 1
Turn signals stay on but hazards work
Posted: Thu Jan 12, 2017 9:52 pm
by fmacnak
Hey guys, new problem. So I haven't driven my bonnie for a few months. I get in and go to use the turn signals and the lights stay on. I tried the flashers and they work fine so I don't think it's a bulb. Not sure if someone has some ideas.
Re: Turn signals stay on but hazards work
Posted: Fri Jan 13, 2017 4:21 am
by 95naSTA
The turn signal flasher is seperate from the 4 way flasher. So the turn one went bad. They're both located under the driver's side dash.
Re: Turn signals stay on but hazards work
Posted: Fri Jan 13, 2017 10:47 am
by J Wikoff
Did you go outside the car and check if the hazards actually flash? It's been a while, but I thought a non-flashing turn signal could mean a bulb was burnt out.
Re: Turn signals stay on but hazards work
Posted: Sat Jan 14, 2017 1:53 pm
by fmacnak
Hi, I did walk around the cat and all the bulbs wereally flashing. I'll replace the turn signal flasher under the dash. Thanks, I didn't know that existed.
Re: Turn signals stay on but hazards work
Posted: Sat Jan 14, 2017 4:55 pm
by 95naSTA
You might want to swap the turn flasher to the 4 way and make sure the problem follows.
Re: Turn signals stay on but hazards work
Posted: Sat Jan 14, 2017 7:28 pm
by fmacnak
Hey guys, that worked. Thanks again!
Re: Turn signals stay on but hazards work
Posted: Fri Jan 20, 2017 8:10 pm
by Bugsi
Suggestion: Edit your original post and add [Solved] to the beginning of the subject.