97 ssei: sudden no start condition
Posted: Thu Jul 21, 2011 11:08 pm
hi,
swmbo drove the car into the garage one night and the next morning, it wont start, i tried my key, nothing.
in retrospect, the fuel pump wasnt running, (it's one year old).
checked the maxifuse, fuses and relay, all good.
battery was a tad weak and it was replaced.
a couple people said to take the after market "ultra-start remote starter" which i did.
it was not soldered or crimped, just wire twisted around wire.
a big orange wire had several strands broken.
the white vats wires (covered with an orange sheath) had a ~4.68 resistor soldered in place to defeat the vats.
my key was read in a vats machine and was determined to be #11, (4.75 ohms). both keys read ~4.68 ohms with my multimeter
i just wrapped these wires together to see if it would start, but it didnt.
sometime during this process, the fuel pump ran for a few seconds and rather than check the pressure at the rail, i tried to start it, no luck.
the security lite is steady upon entry to the car, (with the door open), and flashes 1/sec after cranking and goes out whan the door is shut.
so the fuel pump is not working. i feel it is due to the security, vats, remote starter, pcm but can not find the cause.
is there a way to force the pump to run by over riding these systems?
any other suggestions before i have it towed to the local chevy dealer?
tia
very frustrated,
peter
swmbo drove the car into the garage one night and the next morning, it wont start, i tried my key, nothing.
in retrospect, the fuel pump wasnt running, (it's one year old).
checked the maxifuse, fuses and relay, all good.
battery was a tad weak and it was replaced.
a couple people said to take the after market "ultra-start remote starter" which i did.
it was not soldered or crimped, just wire twisted around wire.
a big orange wire had several strands broken.
the white vats wires (covered with an orange sheath) had a ~4.68 resistor soldered in place to defeat the vats.
my key was read in a vats machine and was determined to be #11, (4.75 ohms). both keys read ~4.68 ohms with my multimeter
i just wrapped these wires together to see if it would start, but it didnt.
sometime during this process, the fuel pump ran for a few seconds and rather than check the pressure at the rail, i tried to start it, no luck.
the security lite is steady upon entry to the car, (with the door open), and flashes 1/sec after cranking and goes out whan the door is shut.
so the fuel pump is not working. i feel it is due to the security, vats, remote starter, pcm but can not find the cause.
is there a way to force the pump to run by over riding these systems?
any other suggestions before i have it towed to the local chevy dealer?
tia
very frustrated,
peter