Page 1 of 1
Intake temp to cold?
Posted: Wed Feb 23, 2011 12:58 pm
by blackbeauty00
since i gutted my air box my SES wont turn off. its bring up the intake tempature is to cold so i replaced it with a new one and it still comes on. Is there anything i can do to get rid of it?
Re: Intake temp to cold?
Posted: Wed Feb 23, 2011 4:21 pm
by 00Beast
I have never heard of an intake temp too cold code and my car has been run in below 0 weather with an FWI. What's the actual number? Pxxxx?
Re: Intake temp to cold?
Posted: Wed Feb 23, 2011 4:26 pm
by yourgrandma
I've had iats well below zero as well. Of course my aeroforce reads it as 65000 degrees though.
Re: Intake temp to cold?
Posted: Wed Feb 23, 2011 4:49 pm
by Archon
I agree that I haven't heard of that code either, and also run a FWI which has seen below zero temperatures. As Beast mentioned, the actual code would be helpful. I'm wondering if it isn't more like coolant temperature below thermostat regulating threshold.
Re: Intake temp to cold?
Posted: Wed Feb 23, 2011 5:06 pm
by blackbeauty00
ill have to get the code # and then put it on here.
Re: Intake temp to cold?
Posted: Wed Apr 06, 2011 2:32 pm
by blackbeauty00
The code number is p0113, it is for iat, high flow of air.
Re: Intake temp to cold?
Posted: Wed Apr 06, 2011 2:52 pm
by J Wikoff
Make sure the IAT is plugged in.
Re: Intake temp to cold?
Posted: Wed Apr 06, 2011 3:10 pm
by blackbeauty00
Its plugged in and I bought s new one and it still does it.
Re: Intake temp to cold?
Posted: Wed Apr 06, 2011 4:29 pm
by 00Beast
P0113 Intake Air Temperature Circuit High Input
That's the official code. Have you checked your wiring harness?
Re: Intake temp to cold?
Posted: Sat Apr 16, 2011 2:53 pm
by blackbeauty00
I looked at my wires going down to the harness and one of them was broke. So I repaired it last night while I was working on my car.