PontiacBonnevilleClub.com

Had to change my 9006ST's today because both of the low beams failed yesterday. They were installed in Oct, 07 (thanks to Jrs3800). Anyway, I was taking the one of the pass side to replace the bulb and in doing so I knocked off the Blue retaining clip and it fell down to the bottom of the chassis and could not locate it. That is the part# that I need for the blue clip or is that clip even required? Thanks.

The blue pin that goes in the connector for the headlight? I don't put mine in, they're too hard to get out. Don't worry about it.

This blue clip?


Its not necessary, but if you want one, I can send it to you. I can cut the wiring to keep it intact, but I'm not sure how to you would get it on...

No, it didn't look like your clip. It was a small "U" shaped clip, solid piece.

Could you possibly get a picture of the one on the other side?

This one then. PM me your address and I'll drop it in an envelope.

harofreak00 wrote:This one then. PM me your address and I'll drop it in an envelope.

Andrew, That's the one. Will send you a PM. Thanks.

It's a wire protector. It acts sorta like a plastic grommet on an A/C cord to your TV, inside the Case of the TV. It helps prevent the wire from pulling out, and or getting cut from sharp bends. It's not 100% foolproof, just meant to help. Not necessary to have it.

CMNTMXR57 wrote:It's a wire protector. It acts sorta like a plastic grommet on an A/C cord to your TV, inside the Case of the TV. It helps prevent the wire from pulling out, and or getting cut from sharp bends. It's not 100% foolproof, just meant to help. Not necessary to have it.

Thanks for the reply. A replacement is on the way.