Re: 2000 Bonnie SE stalling issues
Posted: Sat Apr 15, 2017 10:20 pm
I'll start again monday I'll start again mondayPontiacBonnevilleClub.com
The forum for Pontiac Bonneville enthusiasts
http://www.pontiacbonnevilleclub.com/forum/
2000 Bonnie SE stalling issues
http://www.pontiacbonnevilleclub.com/forum/viewtopic.php?t=50103
Page 3 of 3
I'll start again mondayRe: 2000 Bonnie SE stalling issues
Posted: Sun Apr 16, 2017 9:45 am
No worries Mike , I've been work in on it awile now......thanx for the well wishes and hope you had a happy weekend as wellMKMike wrote:Bummer.
Well, happy Easter or Passover--or simply have a happy weekend!
Re: 2000 Bonnie SE stalling issues
Posted: Mon May 01, 2017 7:28 am
Lol replace your IAC dude u said you saw Improvement go from there and yes there is a wrong way to install TPS lol almost dos it and tired fuel filter?
Re: 2000 Bonnie SE stalling issues
Posted: Mon Jul 17, 2017 9:37 pm
So I got all the codes cleared and took her out on the freeway and opened her up to see what
Would happen........at 90 mph WOT the check engine light came back on and I noticed there was
A roaring sound. The code is p0300 random misfire and now when I accelerate hard , it roars like
An open breather.I'm gonna put a vacuum gage on it the see what's up.my thoughts are A : blown
Intake gasket or B: cracked intake.we all see
Would happen........at 90 mph WOT the check engine light came back on and I noticed there was
A roaring sound. The code is p0300 random misfire and now when I accelerate hard , it roars like
An open breather.I'm gonna put a vacuum gage on it the see what's up.my thoughts are A : blown
Intake gasket or B: cracked intake.we all see
Re: 2000 Bonnie SE stalling issues
Posted: Tue Jul 18, 2017 9:00 am
just for giggles, unplug the maf and see how she runs
Re: 2000 Bonnie SE stalling issues
Posted: Thu Jul 20, 2017 12:29 pm
Lol been down that raod, after two new ones and now an original good one from haro.......no change96 SSEi wrote:just for giggles, unplug the maf and see how she runs
Re: 2000 Bonnie SE stalling issues
Posted: Tue Nov 07, 2017 12:05 pm
Ok I finally found the problem, the Delco ignition module that I put on last year
Had a short in it all along. I found this out yesterday when 3 cylinders mysteriously
Died. Well long story short new module on and problem gone.thanx everyone for the help
And Haro for all the parts lol.
Had a short in it all along. I found this out yesterday when 3 cylinders mysteriously
Died. Well long story short new module on and problem gone.thanx everyone for the help
And Haro for all the parts lol.
Re: 2000 Bonnie SE stalling issues
Posted: Wed Nov 08, 2017 9:44 am
Did you mean to say DELPHI module?Bad67bird wrote:Ok I finally found the problem, the Delco ignition module that I put on last year
I've had some issues with Delphi aftermarket parts but not ACDelco.
Re: 2000 Bonnie SE stalling issues
Posted: Wed Nov 08, 2017 1:23 pm
No I took Haro advise and ordered an ac delco one to
Prevent problems,but no luck lol
Prevent problems,but no luck lol
Re: 2000 Bonnie SE stalling issues
Posted: Wed Nov 08, 2017 2:09 pm
Bummer. Hope it was just a defective ICM.
There are things you wouldn't even think of which will cause ICMs to keep failing.
One thing I wouldn't have suspected is excessive AC voltage leaving the alternator.
Worse still, the ICM isn't the only component that can get damaged by this.
Just something to check.
You might read this article to get more ideas on this; article is on page 2 columns 2 and 3:http://www.wellsve.com/sft503/counterp_v7_i2_20031.pdf
There are things you wouldn't even think of which will cause ICMs to keep failing.
One thing I wouldn't have suspected is excessive AC voltage leaving the alternator.
Worse still, the ICM isn't the only component that can get damaged by this.
Just something to check.
You might read this article to get more ideas on this; article is on page 2 columns 2 and 3:http://www.wellsve.com/sft503/counterp_v7_i2_20031.pdf