PontiacBonnevilleClub.com

Great list, very helpful. thanks

harofreak00 wrote:I've spent many hours working on this update, but I know its not perfect. Feel free to post any questions, comments, additions, etc to further help the community.

Estimated Cost: FREE - $30 + labor, depending on if you have the materials on hand. [/list][/list]

• Filthy wheels
  • Problem: The surface of the rim is covered in brake dust, rust or tar.
    Solution: Wash the wheels the best that you can with soap and water, and then use some Mother’s Mag and Aluminum polish on a rag. You can either work it with your finger, or with a Powerball Mini. http://www.mothers.com/02_products/05100-05101.html
    Estimated Cost: $5-10 + labor

Honestly i wouldnt use Mothers Mag polish. I had rear brakes that looked like dirty gold rims because of all the rust that was on my rotor from the previous owner. SOFT SCRUB powered through and completely shined it up. I had tried Mothers Mag polish but it was barely able to scratch the surface of the rust.

Nothing wrong with the Mothers polish, I use it often when detailing. When I come across filthy wheels though I use an acid wheel cleaner.

The mothers polish was great for the weak rust spots, but it left white crud all over everything that I didnt wipe with a towel, come back five minutes later, and wipe with a towel again. Dont get me wrong, it will get your wheel clean, but general SoftScrub made for a much easier clean.

on my 00 bonneville i get no air to come out of my rear heat/ac ducks in my center councel. i noticed if you pull on the bottom back of it will split and hinges at the top. and then you can feel the duck on the floor that goes to the center coucel i get no air there either. my hvac control wil be set on floor and vent and up front i get air out both the floor and vent any easy solution before i start taking it all apart?

Problem fixed pulled out center council there was carpet stuck between we're the 2 ducks meet

Also theninterior light fuse blowing due to sunvisors

I noticed that the photos for the door water leaks in this topic are missing. Is there any way to get them re posted? Thanks

Bump for a slow 1st post approval...

They aren't missing. For some reason, Photobucket says that we're over our bandwidth limit for the month, so they can't be viewed until next month.

The bandwidth will be reset on the next month cycle which begins on 9/16/13.

If someone wants to pay for the unlimited bandwidth it would be $30/year.

Pontiac Bonneville Club General Collection? lol...

If anyone wants to donate to the bandwidth problem, Paypal me at andrew.suderman @ gmail.com

Help! knocking noise, when I crank my 03 Bonneville Se, then its like a ticking noise. A couple of folks listened, one said engine replacement off the back, the other said it could be rod bearings or lifter.

This is an awesome list. Thanks for this great information.

Girlonfire, you should start your own thread in the 2000-2005 section. Post a video of the noise if possible. That will help us figure it out. Also, where are you located?

I want to thank you for this great thread. I have used several of these write ups. I just now finished installing a Dorman intermediate steering shaft and the link provided was more than helpful with pictures. What a difference that new ISS made! My next project is too install the shift kit I got to get rid of the hard shift.
Thanks again for all the info.

I am having a bunch of problems with acceleration and heavy KR when the boost goes above 3. I have read that it could be a plugged CAT. How often does this happen? is there another way to diagnose the CAT?
Thanks
Wolf

I would post a new question about boost and kr. This is for showing how to fix the problems. You will get more replys when it in a separate post

Great Forum,thank you so much for this, you have know idea how many of these problems my car has.