Re: Hood modification
Posted: Fri May 18, 2012 2:42 pm
It would be hard to make any "scoops" you want if you know how to work metal. A lot cheaper than buying a hood that you are just gonna cut up and waste.
PontiacBonnevilleClub.com
The forum for Pontiac Bonneville enthusiasts
http://www.pontiacbonnevilleclub.com/forum/
Hood modification
http://www.pontiacbonnevilleclub.com/forum/viewtopic.php?t=32632
Page 2 of 2
Re: Hood modification
Posted: Fri May 18, 2012 2:45 pm
if its junk though, its "recycling"
Re: Hood modification
Posted: Fri May 18, 2012 3:28 pm
If its junk its pretty damaged then.Adamus Prime wrote:if its junk though, its "recycling"
Re: Hood modification
Posted: Tue Aug 21, 2012 11:40 am
01bonneSC wrote:Id be looking to have heat escape out the back of the hood. Like reverse what you have now. When the '64 gets done, the hood is getting lifted a little at the cowl with some washers or aluminum spacers to extract the heat.
The grill lets air in to begin with.. putting scoops/vents on the rear of the hood will allow the air to move throughout the entire engine bay. Just like supercars.. the same aspect as fender vents/grills 
Re: Hood modification
Posted: Tue Aug 21, 2012 11:41 am
Woah. Old post. Just noticed.