PontiacBonnevilleClub.com

First I'd commit a crime and bail myself out. Then I would go cam, stage 3 heads, rockers and the rest of the valvetrain, bullet-proof the the trans, get some lightweight aluminum black rims, 4 nitto summer only tires, port the SC, throw an IC on there for good measure, then hit the bars.

Paint it back to the original color but with SSEi front and rear fascias, S3 Supercharged 3800, black rims with a deep lip for the summer, GXPs for the winter, black it out, windows, lights, all the chrome, and lower it about an inch.

I was just looking at the Aerostar, and I'd have to make that a Bonneville on the inside. I'm aware that the floor has a similar enough bolt pattern to accommodate AL7 seats!

10-sec Aerostar on the outside; Bonneville on the inside!

I'm glad everyone is finding this so amusing, because i definitely know i am. I almost forgot about the sound system, i'd have to go with rockford fosgates.

You'd need a lot more than Fosgates to hear over the four L67s in the Aerostar.

Total factory restoration and motor and tranny work by intense

For my PAU...

Two tone, black/tan paint with brick red pinstripe.
Dodge Ram SRT/10 hood cowl and scoop.
Custom spoiler(subtle and low-profile), and front splitter(again, subtle).
Mesh grille.
50% tint all around.
1 1/4" drop front, 1" rear, on stiffer springs/shocks/sways/bushings.
Corvette brakes front, Bonnie GXP brakes rear.



INTENSE Stage 3 Package with Ported GenV and ZZP 2.25" IC.

OR

INTENSE Stage 3 Package with ZZP Stattama turbo kit.

OR!!!

Go nuts. LS7 with LS4 accessories from GPGXP, mated to 4T80E, or M4, if it can take the power...


OR!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Lingenfelter TT LS7 drivetrain swapped into RWD conversion...you did say money was no object...

Put Bonneville badges on a lamborghini

Yes! Yes!