My 93 had 8mm Beldens for series 1 that were put on just before I wrecked it. Rather than getting a new set of 7mm's, I grabbed the front three 8mm ones (rear ones were smashed against firewall).
It ran fine so didn't think anything of it.
Lately, it had been gradually losing power and missing like another wire was going bad.
It was also getting radio interference as a tick at frequency correponding to once per revolution.
I pulled the plugs and found this.

Electrodes on the front 3 pretty much disappeared in 2 or 3k miles.
I put new plugs & wires on it and it ran great but radio noise was still there.
I swapped a good coil in each position one at a time and confirmed the noise as a bad coil.
I didn't think there would be that much difference between the performance of the two styles of wires. I thought the difference was mainly in the insulation thickness.
I also have never had a coil run fine but still make noise like that either.








