driven sprocket support wont go in the way

[wdudetocool]

its sticks out about 2 or 3 mms above case where i cant put cover on. what am i doing wrong?

[harofreak00]

Are you talking about the 4th clutch hub? Push it in further. Twist and push at the same time.

[spoiledred94]

I hsd the same problem. Turned out that top hub was binding with the case. It took like two days to get it in for some unbelievable reason. I think the prongs on my hub were very slightly bent, Honestly don't do this wrong, but, I tapped it in with a hammer and for sure it binded, Took it out and lightly sanded the hub. It took a very long worrisome effort but it went in and the trans worked well.

I am not the authority on this ut be sure it will go in AND turn fairly easy.