Any suggestions? 2000 SSEi

Discuss your 2000-2005 Bonneville SE, SLE, SSEi, Buick Le Sabre 00-05 and Buick Park Avenue 97-05. Please use General Chat for non-mechanical issues, and Performance and Brainstorming for improvements.
Post Reply
thefredman54
SE Member
SE Member
Posts: 12
Joined: Thu May 03, 2012 2:19 pm
Year and Trim: 2000 SSEi
1986 Fiero
Location: Farmland, IN

Any suggestions? 2000 SSEi

Post by thefredman54 »

Okay I have posted this problem once before. Car has a knock when I start it and while its at idle. Doesn't affect performance, or at least it doesnt seem too. Thought it was a bad injector, replaced injector on what seemed to be the bad one from ohm reading. Did not make a difference. Open to ideas and suggestions. Runs rough instead of smooth. Thanks
Last edited by thefredman54 on Sat May 05, 2012 2:08 pm, edited 2 times in total.
redzmonte
Posts like an L67
Posts like an L67
Posts: 1358
Joined: Mon Jun 13, 2011 4:21 am
Year and Trim: 2000 SSEI

Re: Any suggestions? 2000 SSEi

Post by redzmonte »

is it a knock in the engine? it could be a couple things causing it not to run right... I would try removing and cleaning the MAF and if you have a way to scan it check the maf opperation.. a bad MAF would cause it to run bad. MAF are kinda expencive (100ish bux new) so i would say check other things as well before throwing parts at it. I would check the plugs and wires... try unhooking them one at a time and see if the idle/studder changes... that will narrow it to a cylinder... from there you can determine if the plugs are shot, wires are shot, ignition coil is not working or working poorly. if thoes all check out then i would probably do a compression test on all cylinders to make sure its got good compression.. if that comes back low then it could be a bent valve (not to common) or bad rings.

Thats were i would start..

S
Shane "RedZMonte"
2004 Z16 Z06: Virgin
2000 SSEi: Kenwood DDX512, 3.25" MPS, ZZP DP, PLog, Puck Mount, NGK TR7's, DHP Tuned
1995 Monte Z34: T04e "60" turbo, 42.5# injectors, Borla Catback, OBDII swap, DHP Tuned, Much more...
myfirstbonnie
Resident Gearhead
Resident Gearhead
Posts: 5530
Joined: Mon May 19, 2008 10:19 pm
Year and Trim: .
2015 Buick Enclave
2013 Buick Regal GS
Location: Hillsboro, Oregon

Re: Any suggestions? 2000 SSEi

Post by myfirstbonnie »

Please keep this in the same thread:

viewtopic.php?f=18&t=32573
thefredman54
SE Member
SE Member
Posts: 12
Joined: Thu May 03, 2012 2:19 pm
Year and Trim: 2000 SSEi
1986 Fiero
Location: Farmland, IN

Re: Any suggestions? 2000 SSEi

Post by thefredman54 »

got it figured out thanks for the help everyone
Mark Fahey
Posts like an LN3
Posts like an LN3
Posts: 557
Joined: Mon May 26, 2008 10:15 am
Year and Trim: 2000 SSEi, 3.4", FWI, Saner HD sway bars,137K
Location: Morris, Illinois

Re: Any suggestions? 2000 SSEi

Post by Mark Fahey »

It's always good to give as well as receive as in help for the next person. What was the solution?
Post Reply