I just pealed off $$350 to replace this gasket because the mechanic found anti-freese on it. I now suspect a hose below the throttle body may have been leaking. I will watch the coolant levels to see if it gets low.
Anyone have a similar experience??
rip off - anti freeze near intake manifold = new gasket??
- Archon
- Resident Gearhead

- Posts: 8781
- Joined: Mon May 19, 2008 10:30 pm
- Year and Trim: 2014 Cadillac XTS Vsport.
- Location: Grand Rapids, Michigan
Re: rip off - anti freeze near intake manifold = new gasket??
Can you post a picture of which hose you believe is leaking coolant? The only hose in that area that carries coolant that I can think of is the hose from the radiator to the thermostat housing. There's a cover on the lower intake manifold that is sort of hidden behind the crossover pipe that also carries coolant.
By the cost, it would seem that the gasket between the LIM and supercharger was what was replaced. If so, as it was 90% done, the LIM gasket should have been replaced, too.
By the cost, it would seem that the gasket between the LIM and supercharger was what was replaced. If so, as it was 90% done, the LIM gasket should have been replaced, too.
*Gone, but not forgotten* - Black 2000 SSEi, HIR Headlights, Angel Eyes fogs, 3rd brake light overlay, hi-flo cat, 180 degree thermostat, HS 1.9 rockers, LSx yellow springs, Intense FWI, PCM, shift kit, push rods, and 3.4 Pulley. ZZP Power Log.
-
1fatcat
- Posts like an L67

- Posts: 1254
- Joined: Mon Mar 30, 2009 11:18 pm
- Year and Trim: before cars
- Location: Zimmerman, MN
Re: rip off - anti freeze near intake manifold = new gasket??
And if your mechanic did the LIM, he SHOULD have replaced that cover plate gasket too, as it is known to leak.
-
vinnyg
- SE Member

- Posts: 17
- Joined: Fri Mar 12, 2010 10:55 pm
- Year and Trim: 2003 SSEi - red
- Location: Suffolk County NY
Re: rip off - anti freeze near intake manifold = new gasket??
I will get some shots this weekend - it is still leaking something on the driveway after valve cover gaskets and LIM gaskets .
I am obsessed if it is not 100 percent...
I am obsessed if it is not 100 percent...

