Gallery Rules on Image Posting
- All users must read and comply to the rules and posting guidlines listed here.



Search results - "floor"
04_Front_RH_Rust_under_2_40percent.JPG
Looking Up at Floor88 viewsThis is looking up from underneath the car. You can see a hole right through to the interior.
06_Floor_Int_Prep_40percent.JPG
Floor prepared79 viewsThis the floor, passenger side. I cut out as much as I could that was bad and then added metal from here.
12_Floor_Partial_40percent.JPG
Floor Partial Reconstruction81 viewsThis shows the reinforcement I added to the interior. I bolted and welded a heavy piece of metal right above the lift tab. My goal was to make it possible to jack the car at the lift point, and I was successful.
17_Floor_Complete_40percent.JPG
Floor complete77 viewsThis is the floor completed, it was painted with POR-15 and then sealed with 3M seam sealer. As a last step, I pop riveted a thin piece of sheet metal (shown) where your feet rest. It didn't need to be very strong, I just needed to fill in the hole.
19_LH_rust_40percent.JPG
LH rusted85 viewsThis is the left hand side. It wasn't quite as bad as the right hand side, the floor was not involved.
Int_rear_dor.JPG
floors 1993 SSEi53 viewsBought the car for 5 bills without even looking underneath it, Canadian Winters FTW, this is what the floors look like with no carpet. Mmmmm, minty fresh!
   
6 files on 1 page(s)




Copyright - SMF 1.1RC2 Theme created by Billy Bullock, and modified by Pontiac Bonneville Club