Page 1 of 1

Rs730 alarm install

Posted: Fri Jun 06, 2014 6:55 pm
by trigga_b
Ok I can't get my idatalink (solo- ads-alsl-gm) to function properly it keeps flashing red even when I factory reset. I didn't connect any wires to the passkey as the diagram shows not to, idk. So I'm going to wire my alarm in the old hard way. There is a xpresskit bypass already installed for remote start from the previous owner so a lot of the wiring is no problem. Is there a more easier location for wiring these connections?? Also do I need any relays for the door locks?

Neutral Safety Wire- Yellow (-) On Switch Rear of Transmission]***I wired this to Ground is that ok????????????

Trunk Pin Red/Black (-) BCM behind Passenger's Dash] Anywhere else I can get to this????????????

Parking Lights Brown (+) Right Side of Steering Column Light Module*****The old remote start was wired using negative polarity should I keep my tapped wire there or wire it using positive as the rs730 originally had?????

Head Lamp Tan (+) Lamp Control Driver's Dash right of Column Anywhere else easier?????????????

Factory Disarm Light Green (-) Driver's Door at Door Module Blue Connector

Door Trigger Dark Blue (-) Fuse Panel behind Passenger's Dash or BCM] Anywhere else easier????????????????

Door Lock Red/Black (-) Switch Driver's Door Data Link Locks

Door Unlock Orange/Black (-) Must use Wires in Driver's Door

Driver's Lock Gray In Driver's Door

Driver's Unlock Tan In Driver's Door

Passenger Unlock Pink Driver's Door Harness from Rear Door] Rear harness? Could this also be in the driver's front?

Horn Wire Black (-) Steering Column ??????????????????? There's a lot of black wires