Page 1 of 1

Fault code 13

Posted: Sat Apr 19, 2014 4:37 pm
by Karpov
3800 lesabre 1990

SES flashes when i drive.

Code:
13 Oxygen sensor voltage stays between 0.35 and 0.55 volts for 30 seconds when the TPS signal was above 0.55 volts. The engine had been running for at least 40 seconds at normal engine temperature.

Wires etc good. Is oxygen sensor fault? Anything else possible?

Re: Fault code 13

Posted: Mon Apr 21, 2014 3:41 am
by myfirstbonnie
Sounds like a slow sensor. Replace with denso or AC Delco for best results. Bosch doesn't seem to like these motors.

Check on Rock Auto and don't forget about the discount code in general chat.

Re: Fault code 13

Posted: Mon Apr 21, 2014 11:14 am
by Karpov
Okay thanks! Seems that connector plug is loose too...(that where you but wire)