PontiacBonnevilleClub.com
http://www.pontiacbonnevilleclub.com/forum/

2005 Driver Door Electical Harness
http://www.pontiacbonnevilleclub.com/forum/general-chat/topic51430.html
Page 1 of 1

Author:  frntflp [ Thu Feb 01, 2018 12:41 pm ]
Post subject:  2005 Driver Door Electical Harness

Need to remove the driver door (damaged) and replace with a new(er) one. Where is the plug for the electrical harness to the driver door ? Inside the door or inside the "body"/chassis in front of the door opening ?

Trying to figure this out before I start pulling it all apart. Hoping that I can start taking off panels and such in the right direction. (The guy I bought the door from cut all the wires where the harness feeds into the chassis at the front of the door opening). If the connector is in the chassis/body work, then I will have to pull the harness out of the existing door and move it over. or spice a LOT of wires. Hoping the connector is inside the door.

Thanks in advance !

Author:  nos4blood70 [ Thu Feb 01, 2018 7:29 pm ]
Post subject:  Re: 2005 Driver Door Electical Harness

Almost 100% sure the connector is inside the door, but it's been a while since I've gone inside mine.

Author:  JEFFSSSEI [ Thu Feb 01, 2018 7:48 pm ]
Post subject:  Re: 2005 Driver Door Electical Harness

according to GMSI it's in the door, https://drive.google.com/open?id=1EhVpq ... 1TLKh5CPuP (says left door similar - doesn't show the left door in GMSI, but looks like you lucked out.

Author:  ParkAve666 [ Thu Feb 01, 2018 8:48 pm ]
Post subject:  Re: 2005 Driver Door Electical Harness

JEFFSSSEI wrote:
according to GMSI it's in the door, https://drive.google.com/open?id=1EhVpq ... 1TLKh5CPuP (says left door similar - doesn't show the left door in GMSI, but looks like you lucked out.


I know this isnt my thread, but thanks Jeff for the info on hard wiring my radar detector. I would have PM'ed you back but since im too new I guess im not aloud to send PMs yet.

Author:  JEFFSSSEI [ Thu Feb 01, 2018 11:02 pm ]
Post subject:  Re: 2005 Driver Door Electical Harness

ParkAve666 wrote:
JEFFSSSEI wrote:
according to GMSI it's in the door, https://drive.google.com/open?id=1EhVpq ... 1TLKh5CPuP (says left door similar - doesn't show the left door in GMSI, but looks like you lucked out.


I know this isnt my thread, but thanks Jeff for the info on hard wiring my radar detector. I would have PM'ed you back but since im too new I guess im not aloud to send PMs yet.

Your most welcome.

Author:  frntflp [ Fri Feb 02, 2018 12:26 pm ]
Post subject:  Re: 2005 Driver Door Electical Harness

Thank you !! That makes things much easier. :wink:

Author:  ddalder [ Sun Feb 04, 2018 6:47 pm ]
Post subject:  Re: 2005 Driver Door Electical Harness

The connector for the front doors are inside the body for a 2005. The picture shown in the above post is actually a rear door but similar connections exist for the 2000 and perhaps 2001 front doors. For some reason they are different than later years which I suspect was to improve protection from the elements. To access the connector you need, you must remove the brake pedal assembly (or at least move it out of the way) and of course the LF sill plate. The connector you want is also a different style than shown in that diagram. Yours will be a Delphi Lever Lock 150/280 mixed style connector. It is the same connector as your driver's door trim panel (blue lever that you need to flip up to release). Oh yeah, you're going to find it to be a pain to access. Some people cut the heavy rubber sound barrier that the wiring passes through in the foot well to better access it. This isn't necessary, but can make it easier. If you do cut it, be VERY careful. The body shop that fixed my car after it was hit by a snow plow cut it. They also sliced open the sunroof drain hidden behind it! This was one factor in adding to interior water leaks.

Author:  ddalder [ Mon Feb 05, 2018 11:01 am ]
Post subject:  Re: 2005 Driver Door Electical Harness

I don't know if you'll be able to see the photos or not (because they are hosted on photobucket), but this is a project I did a while ago. Many of the pictures show the area you need to access and the connector you're looking for.

post449450.html

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/