PontiacBonnevilleClub.com http://www.pontiacbonnevilleclub.com/forum/ |
|
2000 SLE Thermostat Housing Gasket http://www.pontiacbonnevilleclub.com/forum/general-chat/topic51110.html |
Page 1 of 1 |
Author: | dougtoth [ Sun Oct 29, 2017 5:53 pm ] |
Post subject: | 2000 SLE Thermostat Housing Gasket |
I have a small antifreeze leak coming from under the thermostat housing. I am going to install a thermostat gasket that I ordered. I believe there is not one on there now. Did Pontiac not use a gasket under that housing? Thank you. |
Author: | 96 SSEi [ Sun Oct 29, 2017 8:49 pm ] |
Post subject: | Re: 2000 SLE Thermostat Housing Gasket |
on my 2000, there is an o-ring in a groove surrounding the thermostat - check to see if yours is in good shape. https://www.google.ca/search?q=2000+pon ... Ti2ESWRCFM: you can see both above......wait 2 seconds for the actual pic to load: its from the 'other' site. |
Author: | luke_dubs [ Sun Oct 29, 2017 8:56 pm ] |
Post subject: | Re: 2000 SLE Thermostat Housing Gasket |
There should have been one there (I assume), but if it is leaking from there, then there is not one present. I dealt with the same issue about 3 weeks ago. Make sure you clean the thermostat and the housing surrounding it. It's an easy fix. |
Author: | 00Beast [ Mon Oct 30, 2017 3:15 pm ] |
Post subject: | Re: 2000 SLE Thermostat Housing Gasket |
There isn't a paper gasket between the housing and the intake manifold. There is an o-ring around the thermostat. Make sure both the face of the intake and the face of the housing are clean and flat, and clean them with a scotch-brite if they're not. You shouldn't need a gasket unless something has gotten warped or something. |
Author: | Detailpro116 [ Sat Jan 27, 2018 12:41 pm ] |
Post subject: | Re: 2000 SLE Thermostat Housing Gasket |
I just changed the thermostat and gasket on my 96. It was a paper gasket that ripped in half when I removed the neck. Half the gasket stayed on the block and the other half stayed on the neck. I scraped it all off, installed the new t-stat with the o-ring properly seated and then used some red gasket maker on the neck and reinstalled the whole thing just to be sure. It has not leaked. |
Author: | nos4blood70 [ Sun Jan 28, 2018 12:24 pm ] |
Post subject: | Re: 2000 SLE Thermostat Housing Gasket |
I added some RTV, even after cleaning the mating surfaces there was a tiny trickle of a leak. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |