PontiacBonnevilleClub.com
http://www.pontiacbonnevilleclub.com/forum/

Wiring Harness
http://www.pontiacbonnevilleclub.com/forum/1992/topic52097.html
Page 1 of 1

Author:  gk35 [ Tue Dec 04, 2018 12:27 pm ]
Post subject:  Wiring Harness

1994 Bonneville

Had a small coolant leak around the water pump hose connections. Moved the wiring harness out of the way to gain access to the hose clamps for tightening. Forgot to move them back into place. Alternator cooling fan shredded the wires running down to the AC compressor and sensors on the engine left side :banghead:

Wires leading to ignition coil are intact. Can the wiring harness be replaced only for the AC and engine sensors? Any idea what part # this would be?

Author:  Watcher [ Tue Jul 14, 2020 2:55 pm ]
Post subject:  Re: Wiring Harness

I would just splice them back together using quality butt splices, heat shrink, electrical tape and maybe some added harness conduit.

Author:  95naSTA [ Tue Jul 14, 2020 10:03 pm ]
Post subject:  Re: Wiring Harness

So if it's the ignition module sub harness that's messed up, then yes, that can be replaced without replacing the whole engine harness.

Image

Problem is you'll be hard pressed to find one for a 92-94. A 95+ L36/L67 might be close enough to be plug and play since every connector is the same. Hit up http://www.bonnevillesunlimited.com/ for one if you want to give it a shot.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/