It is currently Fri Apr 19, 2024 4:55 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: 95 SSEi trans failure
PostPosted: Sat May 29, 2010 1:38 pm 
Offline
SE Member
SE Member

Joined: Sun Sep 13, 2009 8:23 am
Posts: 11
Location: Plattsville ON
Year and Trim: 1995 Pontiac Bonneville SSEi , 2008 Grand Prix
The other day driving home, I went to pass a slow car. My car kicked down and sped up no problem. When I got around the other car and went to slow down a bit, I didn't seem to have any power. I pulled over, checked fluids etc, and everything seemed fine. When I went to pull away to drive agan, the car would not go. The only way I had any gear was to put the car in 1st. The car will not shift into any other gear. I have checked linkage and eveything seems fine. Any ideas? Would it need a complete tranny rebuild?


Top
 Profile  
 
PostPosted: Sat May 29, 2010 2:15 pm 
Offline
Retired Admin/Techinfo Admin
Retired Admin/Techinfo Admin

Joined: Mon May 19, 2008 2:08 pm
Posts: 26009
Location: Space Coast, or at least it used to be
Year and Trim: 03 SLE, 95 SE, 95 TS SE
Most likely a rebuild will be in your cards...

Chances are from what you described the trans may have popped a lip seal or an o ring, or lost a thrust washer...

If you shift manually from manual 1-manual 2 will the trans shift?


Top
 Profile  
 
PostPosted: Sat May 29, 2010 2:26 pm 
Offline
SE Member
SE Member

Joined: Sun Sep 13, 2009 8:23 am
Posts: 11
Location: Plattsville ON
Year and Trim: 1995 Pontiac Bonneville SSEi , 2008 Grand Prix
No it will not shift. The car has sat for a few days now. It rolled back out the driveway, and went for a short drive. It went in drive for about 1/4 mile driving slow. Then did the same thing again.


Top
 Profile  
 
PostPosted: Sat May 29, 2010 2:30 pm 
Offline
SE Member
SE Member

Joined: Sun Sep 13, 2009 8:23 am
Posts: 11
Location: Plattsville ON
Year and Trim: 1995 Pontiac Bonneville SSEi , 2008 Grand Prix
Anyone know what acomplete rebuild might cost? The car is getting old and only worth so much.


Top
 Profile  
 
PostPosted: Sat May 29, 2010 2:37 pm 
Offline
Retired Admin/Techinfo Admin
Retired Admin/Techinfo Admin

Joined: Mon May 19, 2008 2:08 pm
Posts: 26009
Location: Space Coast, or at least it used to be
Year and Trim: 03 SLE, 95 SE, 95 TS SE
1200-1600 depending....

Hard to tell you what to do... I rebuilt the one for my van about 20,000 miles ago... The failure was about the same as yours... I spent $650 in parts alone... Parts will generally run $600-800


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 5 hours [ DST ]


Related topics
 Topics   Author   Replies   Views   Last post 
There are no new unread posts for this topic. possible early trans failure sign??

ptrfair

7

1272

Mon Sep 21, 2009 4:22 am

Need For Steve View the latest post

There are no new unread posts for this topic. 95-03 Upper Intake Failure / LIM gasket failure information

bill buttermore

0

4510

Sat May 24, 2008 4:20 pm

bill buttermore View the latest post

There are no new unread posts for this topic. 98 SSEi available for parts etc Front Subframe failure

Katrutt

1

1051

Fri Dec 25, 2020 8:06 am

Skilyleski View the latest post

There are no new unread posts for this topic. Series I L67 Lower Intake Manifold Gasket failure (94 SSEi).

Highway Patrol

2

811

Fri Oct 23, 2020 10:28 pm

RJolly87 View the latest post

There are no new unread posts for this topic. ssei trans ?

Adam Marcum

10

1951

Wed Jun 04, 2008 12:01 pm

LakevilleSSEi View the latest post

 


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group


phpBB SEO