| PontiacBonnevilleClub.com http://www.pontiacbonnevilleclub.com/forum/ |
|
| How to bleed brakes after replacing master cylinder lines? http://www.pontiacbonnevilleclub.com/forum/2000-2005-other-than-gxp/topic52119.html |
Page 1 of 1 |
| Author: | 2000_bonne [ Sat Dec 29, 2018 5:22 am ] |
| Post subject: | How to bleed brakes after replacing master cylinder lines? |
So the master cylinder reservoir was not dry, but anyways I had to replace the two lines from the M.C to the ABS module. Is there any special way to go about bleeding it? Do I just pop open the caliper screws and wait for things to bleed like normal? Right now it has little or no braking power. It barely had any before because one of the M.C. lines was leaking real bad. Thank you. |
|
| Author: | 96 SSEi [ Tue Jan 22, 2019 4:19 pm ] |
| Post subject: | Re: How to bleed brakes after replacing master cylinder line |
hi, i would bleed all 4 wheels . fill mc. pump brakes till it stiffens - with pedal down open bleed screw - close bleed screw now let pedal up and pump repeat till just clean fluid comes out do this to all wheels go for drive and engage abs on sand if it still soft, bleed again all 4 |
|
| Author: | nos4blood70 [ Tue Jan 22, 2019 5:30 pm ] |
| Post subject: | Re: How to bleed brakes after replacing master cylinder line |
Bleed all 4 like normal. You definitely have air in the lines. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|