It is currently Fri Mar 29, 2024 7:46 am

All times are UTC - 5 hours [ DST ]


Search found 9118 matches
Search these results:

Author Message

 Forum: Everything Electrical and Electronic   Topic: 05 se no start security

 Post subject: Re: 05 se no start security
Posted: Mon Jan 08, 2024 3:40 pm 

Replies: 7
Views: 381


You shouldn't have to do a security relearn after replacing an ignition switch, unless you replaced, damaged, or screwed up in the installation of the Theft Deterrent Exciter Module. It should have stayed attached to the cylinder when you pulled it out of the switch. Did you run into any issues? htt...

 Forum: 2000-2005 (other than GXP)   Topic: Engine Turns Off @ Normal Temp

Posted: Sun Jan 07, 2024 7:30 pm 

Replies: 5
Views: 308


Crank and Cam sensors rarely fail at the same time. It would make more sense that the wiring harness was bad. Since those 2 sensors are the main control for spark control, I'm assuming you have an issue with that harness or the ground and you're losing spark. The harness is small and easy to replace.

 Forum: 2000-2005 (other than GXP)   Topic: PCM Tray location?

 Post subject: Re: PCM Tray location?
Posted: Sat Jan 06, 2024 11:22 pm 

Replies: 1
Views: 160


Just a couple of well placed self-tappers.

 Forum: 2000-2005 (other than GXP)   Topic: Parasitic draw

 Post subject: Re: Parasitic draw
Posted: Fri Jan 05, 2024 3:48 pm 

Replies: 6
Views: 212


You're barking up the wrong tree with the grounds... grounds.png You could start by isolating which fuse box its coming from. Disconnect the battery cable going to the under-hood fuse box. That is where the starter would be getting its power from. If no change, disconnect the cable going to the rear...

 Forum: 2000-2005 (other than GXP)   Topic: Parasitic draw

 Post subject: Re: Parasitic draw
Posted: Fri Jan 05, 2024 2:25 pm 

Replies: 6
Views: 212


You must be reading your meter wrong. It should be limited to 10 amps. 36amps is a HUGE load for nothing running.

You've removed every single fuse from both fuses boxes and it never dropped?

 Forum: 2000-2005 (other than GXP)   Topic: Parasitic draw

 Post subject: Re: Parasitic draw
Posted: Fri Jan 05, 2024 12:31 pm 

Replies: 6
Views: 212


You simply need to do a parasitic draw test. Hook your multimeter set to amps in line of the negative battery terminal. Close the latches on the rear doors while keeping the doors open (use a screwdriver). Wait for the electronics to sleep (usually a minute or two). Normal draw is 50 milliamps or le...

 Forum: 2000-2005 (other than GXP)   Topic: 2000 SLE No start after replacing coils and ICM

Posted: Fri Jan 05, 2024 10:21 am 

Replies: 3
Views: 157


Remove all 6 spark plug wires from the top of the coils, leave the wires hanging. Have someone help you try to start the car while you watch the coils. You should see nice blue zap coming from each coil grounding out to itself. The only think you could eff up would be trying to touch the arc, it wou...

 Forum: 2000-2005 (other than GXP)   Topic: 2000 SLE No start after replacing coils and ICM

Posted: Thu Jan 04, 2024 6:37 pm 

Replies: 3
Views: 157


You need to verify fuel and spark. See if you have fuel at the Schrader valve on the rail. Pull the spark plug wires off at the coils and check to see if you have blue arcing on all 3 coils.

 Forum: Performance & Brainstorming   Topic: I hope I don't get chastised for this 2007 Lucerne CXL

Posted: Fri Dec 29, 2023 11:27 am 

Replies: 4
Views: 683


http://www.gmtuners.com/transmission/ only goes up to 2006 for some reason

Looking around on https://www.car-part.com it looks like they interchange with nothing, only 2007 Lucerne CXL 3.8. The ones I saw had the PA tag, which means 2.86 ratio.

 Forum: 1992-1999   Topic: Starting without keys

 Post subject: Re: Starting without keys
Posted: Wed Dec 20, 2023 10:21 am 

Replies: 4
Views: 165


Across town is all? The closest one for me is 30 miles away. At least call them up and explain the situation and they may offer to help you. Might need to try a few different dealers.

 Forum: 1992-1999   Topic: Starting without keys

 Post subject: Re: Starting without keys
Posted: Tue Dec 19, 2023 5:09 pm 

Replies: 4
Views: 165


Stop in at a GM dealer with the VIN and proof of ownership and they'll be able to look up which of the 15 key blanks it used. Then you'll be able to install the correct resistor without having to guess and check.

Image

 Forum: 2000-2005 (other than GXP)   Topic: Summit Racing UIM replacement

Posted: Tue Dec 19, 2023 10:07 am 

Replies: 4
Views: 169


I've personally installed dozens of Dorman's with no come-backs.

 Forum: 1992-1999   Topic: No power supply to my windows..

Posted: Tue Dec 19, 2023 10:06 am 

Replies: 10
Views: 241


If you look at the schematic for the right side window motors you'll see the radio fuse is the trigger wire for the power window relay. Was this the problem the entire time?

Image

 Forum: 1992-1999   Topic: No power supply to my windows..

Posted: Fri Dec 15, 2023 2:15 pm 

Replies: 10
Views: 241


https://imgur.com/J7aCVCo.jpg https://imgur.com/LuqI9P2.jpg (1) S510 (2) P500 (3) S505 (4) S506 (5) C210 (6) C212 (7) S504 (8) S503 (9) S502 (10) Traction Control Switch( if Equipped) (11) S501 (12) S500 (13) LH Front Power Window Motor (RH Similar) (14) Power Window Control Module (15) C502 (LH) C...

 Forum: 1992-1999   Topic: No power supply to my windows..

Posted: Fri Dec 15, 2023 10:34 am 

Replies: 10
Views: 241


Probably a bad master window switch. Power Windows Circuit Description A permanent magnet motor operates each power window. Each motor raises or lowers the glass when voltage is supplied. The direction the motor turns depends on the polarity of the supply voltage. The LH front power window switch co...

 Forum: Introductions for new members   Topic: Diagnostic Hell

 Post subject: Re: Diagnostic Hell
Posted: Wed Dec 13, 2023 11:01 am 

Replies: 1
Views: 225


New members need approval before your posts show up, I approved this one and deleted all your other submissions ;)

What schematics are you looking for?

 Forum: 2000-2005 (other than GXP)   Topic: Remove cover over supercharger

Posted: Tue Nov 21, 2023 9:35 am 

Replies: 3
Views: 180


Keep twisting the oil cap open and it will twist the neck so you can remove them as a single piece.

 Forum: Introductions for new members   Topic: Bonneville starts n stalls

Posted: Sat Nov 18, 2023 11:32 am 

Replies: 1
Views: 318


Possibly the MAF sensor. Any codes?

 Forum: Your Ride: Pics and Videos   Topic: Penny the 2003 SLE

 Post subject: Re: Penny the 2003 SLE
Posted: Mon Nov 13, 2023 3:20 pm 

Replies: 383
Views: 47375


The codes will store as history codes and will identify which wheel has the fault.

 Forum: Introductions for new members   Topic: Hi (again)! Returning after many years away...

Posted: Mon Nov 13, 2023 10:10 am 

Replies: 4
Views: 329


Welcome back, I remember the name :beerchug:
Sort by:  
Page 4 of 456 [ Search found 9118 matches ]


All times are UTC - 5 hours [ DST ]


Jump to:  
Powered by phpBB® Forum Software © phpBB Group


phpBB SEO