It is currently Thu Apr 18, 2024 2:23 pm

All times are UTC - 5 hours [ DST ]


Search found 9125 matches
Search these results:

Author Message

 Forum: 2000-2005 (other than GXP)   Topic: OEM Radio Anti Theft Question

Posted: Thu Jan 11, 2024 6:21 pm 

Replies: 6
Views: 375


The radio and fobs are two completely different systems that work independently of each other.

Did you just purchase the car or swap radios yourself? The anti-theft feature can only be unlocked with a dealer level Tech2 or similar high end scan tool.

 Forum: 2000-2005 (other than GXP)   Topic: Wheels for '05 SE

 Post subject: Re: Wheels for '05 SE
Posted: Thu Jan 11, 2024 10:01 am 

Replies: 6
Views: 446


No tire pressure sensors ever in the Bonneville. They use the wheel speed sensors to detect if there is a flat by the diameter of the tire.

An 18" wheel is almost always going to be heavier than a 16" wheel. The 18" GXP wheel weighs 24lbs, not sure about the steels.

 Forum: 2000-2005 (other than GXP)   Topic: Wheels for '05 SE

 Post subject: Re: Wheels for '05 SE
Posted: Wed Jan 10, 2024 6:09 pm 

Replies: 6
Views: 446


Lots of people have upgraded to GXP wheels or any aftermarket wheel. A simple Google search will give you ideas to what they would look like. As long as you get a tire that is similarly sized you will have no issues with the instruments. 235/50R18 on the GXP will be similar to your 226/60R16 on your...

 Forum: 1992-1999   Topic: Throttle cable

 Post subject: Re: Throttle cable
Posted: Wed Jan 10, 2024 6:00 pm 

Replies: 2
Views: 380


Disconnect it from the throttle body first, then untwist the cable from the module and then remove the cable from the ribbon connector.

 Forum: 2000-2005 (other than GXP)   Topic: Engine Turns Off @ Normal Temp

Posted: Mon Jan 08, 2024 6:55 pm 

Replies: 5
Views: 324


You'd be testing for continuity on each individual wire, but if its an intermittent issue, than it might be a partial break where the circuit fails dependent on temperature or position. Easier to just replace the harness and be done with it.

 Forum: Everything Electrical and Electronic   Topic: 05 se no start security

 Post subject: Re: 05 se no start security
Posted: Mon Jan 08, 2024 5:41 pm 

Replies: 7
Views: 423


There is no switched power going to the radio.

 Forum: Everything Electrical and Electronic   Topic: 05 se no start security

 Post subject: Re: 05 se no start security
Posted: Mon Jan 08, 2024 4:45 pm 

Replies: 7
Views: 423


Glad it was something easy.

 Forum: Everything Electrical and Electronic   Topic: 05 se no start security

 Post subject: Re: 05 se no start security
Posted: Mon Jan 08, 2024 3:40 pm 

Replies: 7
Views: 423


You shouldn't have to do a security relearn after replacing an ignition switch, unless you replaced, damaged, or screwed up in the installation of the Theft Deterrent Exciter Module. It should have stayed attached to the cylinder when you pulled it out of the switch. Did you run into any issues? htt...

 Forum: 2000-2005 (other than GXP)   Topic: Engine Turns Off @ Normal Temp

Posted: Sun Jan 07, 2024 7:30 pm 

Replies: 5
Views: 324


Crank and Cam sensors rarely fail at the same time. It would make more sense that the wiring harness was bad. Since those 2 sensors are the main control for spark control, I'm assuming you have an issue with that harness or the ground and you're losing spark. The harness is small and easy to replace.

 Forum: 2000-2005 (other than GXP)   Topic: PCM Tray location?

 Post subject: Re: PCM Tray location?
Posted: Sat Jan 06, 2024 11:22 pm 

Replies: 1
Views: 183


Just a couple of well placed self-tappers.

 Forum: 2000-2005 (other than GXP)   Topic: Parasitic draw

 Post subject: Re: Parasitic draw
Posted: Fri Jan 05, 2024 3:48 pm 

Replies: 6
Views: 228


You're barking up the wrong tree with the grounds... grounds.png You could start by isolating which fuse box its coming from. Disconnect the battery cable going to the under-hood fuse box. That is where the starter would be getting its power from. If no change, disconnect the cable going to the rear...

 Forum: 2000-2005 (other than GXP)   Topic: Parasitic draw

 Post subject: Re: Parasitic draw
Posted: Fri Jan 05, 2024 2:25 pm 

Replies: 6
Views: 228


You must be reading your meter wrong. It should be limited to 10 amps. 36amps is a HUGE load for nothing running.

You've removed every single fuse from both fuses boxes and it never dropped?

 Forum: 2000-2005 (other than GXP)   Topic: Parasitic draw

 Post subject: Re: Parasitic draw
Posted: Fri Jan 05, 2024 12:31 pm 

Replies: 6
Views: 228


You simply need to do a parasitic draw test. Hook your multimeter set to amps in line of the negative battery terminal. Close the latches on the rear doors while keeping the doors open (use a screwdriver). Wait for the electronics to sleep (usually a minute or two). Normal draw is 50 milliamps or le...

 Forum: 2000-2005 (other than GXP)   Topic: 2000 SLE No start after replacing coils and ICM

Posted: Fri Jan 05, 2024 10:21 am 

Replies: 3
Views: 182


Remove all 6 spark plug wires from the top of the coils, leave the wires hanging. Have someone help you try to start the car while you watch the coils. You should see nice blue zap coming from each coil grounding out to itself. The only think you could eff up would be trying to touch the arc, it wou...

 Forum: 2000-2005 (other than GXP)   Topic: 2000 SLE No start after replacing coils and ICM

Posted: Thu Jan 04, 2024 6:37 pm 

Replies: 3
Views: 182


You need to verify fuel and spark. See if you have fuel at the Schrader valve on the rail. Pull the spark plug wires off at the coils and check to see if you have blue arcing on all 3 coils.

 Forum: Performance & Brainstorming   Topic: I hope I don't get chastised for this 2007 Lucerne CXL

Posted: Fri Dec 29, 2023 11:27 am 

Replies: 4
Views: 859


http://www.gmtuners.com/transmission/ only goes up to 2006 for some reason

Looking around on https://www.car-part.com it looks like they interchange with nothing, only 2007 Lucerne CXL 3.8. The ones I saw had the PA tag, which means 2.86 ratio.

 Forum: 1992-1999   Topic: Starting without keys

 Post subject: Re: Starting without keys
Posted: Wed Dec 20, 2023 10:21 am 

Replies: 4
Views: 188


Across town is all? The closest one for me is 30 miles away. At least call them up and explain the situation and they may offer to help you. Might need to try a few different dealers.

 Forum: 1992-1999   Topic: Starting without keys

 Post subject: Re: Starting without keys
Posted: Tue Dec 19, 2023 5:09 pm 

Replies: 4
Views: 188


Stop in at a GM dealer with the VIN and proof of ownership and they'll be able to look up which of the 15 key blanks it used. Then you'll be able to install the correct resistor without having to guess and check.

Image

 Forum: 2000-2005 (other than GXP)   Topic: Summit Racing UIM replacement

Posted: Tue Dec 19, 2023 10:07 am 

Replies: 4
Views: 181


I've personally installed dozens of Dorman's with no come-backs.

 Forum: 1992-1999   Topic: No power supply to my windows..

Posted: Tue Dec 19, 2023 10:06 am 

Replies: 10
Views: 254


If you look at the schematic for the right side window motors you'll see the radio fuse is the trigger wire for the power window relay. Was this the problem the entire time?

Image
Sort by:  
Page 4 of 457 [ Search found 9125 matches ]


All times are UTC - 5 hours [ DST ]


Jump to:  
Powered by phpBB® Forum Software © phpBB Group


phpBB SEO