It is currently Sun Dec 16, 2018 8:17 pm

All times are UTC - 5 hours [ DST ]


Search found 8633 matches
Search these results:

Author Message

 Forum: 2000-2005 (other than GXP)   Topic: fuel injectors?

 Post subject: Re: fuel injectors?
Posted: Mon Dec 03, 2018 10:40 am 

Replies: 12
Views: 196


Get a scantool that can read live data and then watch the misfires to see which cylinder(s) is your culprit. That will eliminate a lot of diagnosing. Once you figure out what cylinder, pull the spark plug wire off the coil to see if its getting spark. If you have spark there and you have new plugs ...

 Forum: 2000-2005 (other than GXP)   Topic: fuel injectors?

 Post subject: Re: fuel injectors?
Posted: Fri Nov 30, 2018 10:10 am 

Replies: 12
Views: 196


Bleed off any fuel pressure at the schrader valve. Remove the 4-10mm nuts that hold the fuel rail down and then pry it up. You can leave the fuel lines connected. Release the clips and then wiggle/pull out the injectors.

 Forum: 2000-2005 (other than GXP)   Topic: fuel injectors?

 Post subject: Re: fuel injectors?
Posted: Thu Nov 29, 2018 3:58 pm 

Replies: 12
Views: 196


Get a scantool that can read live data and then watch the misfires to see which cylinder(s) is your culprit. That will eliminate a lot of diagnosing. Once you figure out what cylinder, pull the spark plug wire off the coil to see if its getting spark. If you have spark there and you have new plugs a...

 Forum: 1992-1999   Topic: Salvage Parts Question

 Post subject: Re: Salvage Parts Question
Posted: Wed Nov 28, 2018 4:10 pm 

Replies: 3
Views: 136


Nothing 2000+ will be compatible. It was a complete platform redesign.

This is a discontinued part, no dealers will have it. You'll need to source it used somewhere. It can come from a Bonneville or LeSabre.

 Forum: 1992-1999   Topic: 95 BUICK PA NA SOUND FROM LEFT FRONT WHEEL

Posted: Wed Nov 14, 2018 12:59 pm 

Replies: 5
Views: 188


Wheel bearings can sometimes be tricky to determine what side is bad. You are talking entirely about the left front, have you looked into the right front? I always replace wheel bearings in pairs because if one side failed, the other is probably on its way out.

 Forum: Audio (and aftermarket electronics)   Topic: 2005 gxp stereo type?

 Post subject: Re: 2005 gxp stereo type?
Posted: Tue Nov 13, 2018 10:06 am 

Replies: 2
Views: 174


Yes, Monsoon. Yes, better than a lower trim. It's an 8-speaker system with an amplifier. The lower trims have 4-6 speakers with no amplifier.

 Forum: Bonneville GXP/Northstar Powered Cars   Topic: Radiator Replacement 05 GXP

Posted: Mon Nov 12, 2018 12:21 pm 

Replies: 1
Views: 1377


Once you remove the airbox and the upper radiator support brace with the 4-15mm bolts, you'll have lots of room to do the job. The fans are just 2-10mm bots and the condenser is also 2-10mm bolts. Burping the coolant system will be the most challenging part.

 Forum: 1992-1999   Topic: Shift Indicator lights went dim. 92 SSE

Posted: Thu Nov 08, 2018 11:25 am 

Replies: 1
Views: 159


I remember it being similar to a #194 bulb, and then its delivered via a fiber optical tube thing.

After removing the shifter knob, remove 2 screws in the ash tray and then the whole assembly pivots up.

 Forum: Introductions for new members   Topic: An 01 Bonneville SE with no door panels or switches.

Posted: Fri Nov 02, 2018 9:40 am 

Replies: 3
Views: 172


A Bonneville SE isn't really considered a luxury car, but it will certainly be closer to that status after having door panels.

I have all the parts you could need. I'm located in MN, where are you?

 Forum: 2000-2005 (other than GXP)   Topic: 2000 SLE Security Question

Posted: Fri Oct 26, 2018 11:08 am 

Replies: 5
Views: 252


Random security problems when it's cold out is a common Bonneville problem. I don't have any answers for you though.

 Forum: General Chat   Topic: supercharger top vacuum tee oring

Posted: Thu Oct 25, 2018 12:45 pm 

Replies: 4
Views: 185


They are always stretched out. I tried a couple different ones from my standard o-ring kit and got one to work. I'm assuming you have the vacuum tree, just grab some and start test fitting...

 Forum: General Chat   Topic: service manuals...

 Post subject: Re: service manuals...
Posted: Thu Oct 11, 2018 11:04 am 

Replies: 2
Views: 250


I'm using the Techline ESI and I see nothing of the C101 connector end view. I've attached the Engine Controls Connector End Views.

 Forum: 2000-2005 (other than GXP)   Topic: 2001 SSEI Front Axles

 Post subject: Re: 2001 SSEI Front Axles
Posted: Tue Oct 09, 2018 9:11 am 

Replies: 2
Views: 210


Yes they are different because the SSEi has a bigger differential and larger diameter axle.

Driver sides are fully interchangeable. Passenger side is not.

 Forum: Bonneville GXP/Northstar Powered Cars   Topic: Front Impact Sensor Testing

Posted: Wed Oct 03, 2018 9:26 am 

Replies: 2
Views: 1609


Get a scantool that can properly read the body codes. A regular code reader will not do it. You're only throwing the parts cannon until you get the code.

 Forum: 2000-2005 (other than GXP)   Topic: Instrument cluster lights

Posted: Fri Sep 28, 2018 5:35 pm 

Replies: 3
Views: 219


I'm your guy. Send me a PM or email: andrew.suderman@gmail.com or call/text 507.220.2000

 Forum: 2000-2005 (other than GXP)   Topic: Sunroof stopped working

 Post subject: Re: Sunroof stopped working
Posted: Sat Sep 15, 2018 11:22 pm 

Replies: 6
Views: 478


For the 5-10 minutes it takes to remove the seats, you'll save that time in trying to get it out undamaged.

 Forum: 2000-2005 (other than GXP)   Topic: Sunroof stopped working

 Post subject: Re: Sunroof stopped working
Posted: Sat Sep 15, 2018 6:47 pm 

Replies: 6
Views: 478


It is possible to leave them in there, but you'll probably damage your headliner trying to remove it.

 Forum: 2000-2005 (other than GXP)   Topic: Sunroof stopped working

 Post subject: Re: Sunroof stopped working
Posted: Sat Sep 15, 2018 11:49 am 

Replies: 6
Views: 478


Some plastic part of the track assembly is broken, jamming it up. There is no fix other than replacement of the entire assembly, which requires removal of the headliner, interior trim and likely the seats.

 Forum: General Chat   Topic: Air Compressor Running- your $.02 Please

Posted: Wed Sep 12, 2018 6:06 pm 

Replies: 2
Views: 342


It's pretty common for the lines to rub a hole where they are clipped onto the body about 12" from the shock. I'd also replace the shocks if there is any bounce in the rear end. Currently $43 on Amazon: https://amazon.com/dp/B000C55T7W/

 Forum: 2000-2005 (other than GXP)   Topic: Steering wheel hub adaptor

Posted: Wed Sep 12, 2018 6:02 pm 

Replies: 7
Views: 522


36 tooth is correct, but I measured the shaft closer to 5/8".
Sort by:  
Page 1 of 432 [ Search found 8633 matches ]


All times are UTC - 5 hours [ DST ]


Jump to:  
Powered by phpBB® Forum Software © phpBB Group


phpBB SEO