Great, thanks for the info.

Does the 3.8 engine have a Heat Riser Vavle or anything comparable?

http://autorepair.about.com/library/glossary/bldef-301.htm

Definition: A control valve between the exhaust manifold and exhaust pipe on one side of a V8 or V6 engine that restricts the flow of exhaust causing it to flow back ...

Where does the water usually get in that causes damage to the module?

Thanks. I don't know that I have a leak at all, not even sure if the module is dead. I get "AIRBAG PROBLEM" scrolling on the driver info screen. The problem has come and gone a few times so just want to check for loose connections or corrosion at this point.

I'm pulling my front/passenger seat to try fix an airbag problem. Anyone know what size of Torx bit is needed for the seat belt rail thing?

I have no idea. The original engine failed last year and so a used one went in. Came with no maintenance records. I just know it's from a cared for car. Since that time there hasn't been much use, maybe a few hundred miles. 106,000 miles on the engine.

My trunk leaks also. I'm pretty sure it gets in around the power antenna as the drain tube keeps slipping off. Take a look and make sure it's not that.

The past week I've noticed sometimes on start up the car runs rough, shakes a little, like a "put put put" sound. On pick-up it does it too, but around 40-50mph it stops and runs as normal. There are no warning lights or anything glowing. I do know there is a hole in the muffler that has been ...

...Post Deleted...

Yes, you have a BCM (Blower Control Module) if you have Digital Electronic Climate Control. It looks like this:

http://ecx.images-amazon.com/images/I/41R8VINsmHL._SL500_.jpg

I'm unaware of any way to test though, but it does seem strange that 8 of them would be dead and dead in such a way to cause ...

Thanks for posting! I live 2 feet from the ocean and my car is actually perfect.....

................Once you scratch off a 1/4 inch of rust it's like new under there....

Thanks! Just what I needed. I'm looking for the opposite now - pictures of healthy frames.

If anyone has any pictures of rusted out/not safe to drive frames please post them. I've only been able to find these (link) pics via search but this is the sort of thing I'm looking for.

http://www.pontiacbonnevilleclub.com/fo ... 29#p108129

Thanks

I've never used Plast-X, I'll check it out. Thanks

Anyone know anything that will clean up the yellow-ish color film that sometimes builds up on plastic lenses? My corner lamps are pretty nasty looking. The headlights are crystal clear but the corners look frosted and dirty-yellow. Any advice? Read about WD-40 or AJAX doing it but I'm not sure...

???

UPDATE: The problem wasn't the motor. It was the master switch on the driver side. Replaced it and everything works as it should.

Today I pulled the door panel and motor. Leaving the motor plugged in I tried the switch and it worked, but only in one switch direction - UP. I guess it still has to be replaced, there's nothing I can do with it?

Are the motors held in with bolts or some kind of rivets that will need to be drilled?

Is there a How-To or Step by Step guide on how to install a new PW motor on a 92-99?

Ok, so anyway, in the meantime. Just incase I wanted to pick up another latch to replace my now badly bent one anyone know what models are a match?