Ok, I crawled under and found the fuel pump connector. It has two wires( grey and white) coming from front of car, then a grey/ white going toward rear of car. Using a dmm set at 20 dcv I probed the grey wire at the connector(the one from front of car) using positive and grounded the negative to the ...

Did fuel pump bypass using green connector behind battery. Did not start... Pump did not prime. It primed yesterday. I visually checked fuse.. will check with mulimeter..

Ok will try that. Thanks!

Update. It just cranked and ran for about 2 min. It still needed feathering.. after let off gas pedal, it died. I now hear fuel pump primer working, but car acts like starving for gas. Only thing not replaced on this 95 is the crank position sensor. While cranking(before it started) I observed the ...

Hello, I cranked it up, drove about 1\4 mile to stop sign. As I pulled out, it lost power. I quickly turned around and headed home feathering the gas. Got home it died. Tried to start again and then crank no start. Over the next couple of days, it mostly cranked no start but did run smoothly for 2 ...

Thanks! I read where the series 2 will work if you bend the bracket a little..buying one today!

Hello, I own a 95 ssei. Been getting code 0640 on my actron 9145 (qdm#1 fault). Did a live data check and it showed boost at 100% at idle. Is this normal? I took the boost solenoid off and checked resistance. It came in at 195 ohms. I read where it should be between 500k and 1.5 m. So do I need a ...

Hello, I am getting quad module driver #1 fault on my 95 Bonneville ssei. My understanding is the following 4 components are controlled by this. Low speed fan,TCC apply, Evap cannisters purge, and boost bypass valve. My actron scanner says code 0640.. The car is showing no symptoms and runs fine ...