It is currently Thu Mar 28, 2024 4:12 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 113 posts ]  Go to page Previous  1, 2, 3, 4, 5, 6  Next
Author Message
PostPosted: Wed Feb 28, 2018 8:16 am 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
Tried new plug wires again. Nothing.

Iac was good too.

Cleaned maf also.


Now i but new plugs because old ones was fueled. I must try start pilot too


Top
 Profile  
 
PostPosted: Wed Feb 28, 2018 12:30 pm 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
Is this normal sparking in waste spark? Same things in every wire.

https://aijaa.com/B3XX2f

There is video for my start with strobo.


Top
 Profile  
 
PostPosted: Thu Mar 01, 2018 3:16 pm 
Offline
Posts like an L67
Posts like an L67

Joined: Thu May 01, 2014 9:37 pm
Posts: 1301
Year and Trim: 1993 SLE
1998 SE
2001 SSEI
2002 SSEI
That doesn't look like I would expect it to.
Assuming this is not a problem with your timing light, then it's not getting spark sometimes.
Since you said this happens on all wires, the problem is not a single bad coil and it is not likely that all coils are bad.

You'll have to figure out if that is from a problem with the ICM or the crankshaft position sensor.

The pages here show you how to test these:
http://easyautodiagnostics.com/gm/3.8L/ ... sor-test-1
http://troubleshootmyvehicle.com/gm/3.8 ... k-sensor-1


Top
 Profile  
 
PostPosted: Thu Mar 01, 2018 5:56 pm 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
Can crank sensor do intermitted spark? Its usually shuts spark off?

Same spark in every six wires. I did not regonized that at short start but longer start it appeared.

Maybe spark is also too weak under compression?


Maybe i just order new icm and coil. New crank sensor is on my garage because i ordered it just in case.

Outside -30 celcius so wire and anything else works wont be nice :)


Top
 Profile  
 
PostPosted: Wed Mar 14, 2018 12:36 pm 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
New icm and coil.

No start :(

I check later that spark is coming (new parts allready broken?)


What is next to check?


Top
 Profile  
 
PostPosted: Wed Mar 14, 2018 1:54 pm 
Offline
Posts like a Northstar
Posts like a Northstar

Joined: Sun Aug 22, 2010 11:11 pm
Posts: 1813
Location: Ontario, Canada
Year and Trim: 2000 Bonniville SSEi L67
crank position sensor - check it

_________________
poverty forces one to do unorthodox things

2000 SSEi
past rides:
1996 SSEi
1992 GTP
1987 Grand Am


Top
 Profile  
 
PostPosted: Wed Mar 14, 2018 4:44 pm 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
96 SSEi wrote:
crank position sensor - check it

No start guide said that if spark is coming, crank sensor is fine. And that meaned both signals. Was this guide rubbish?



Is there hint for set new sensor right? I remember that i get plastic tool with it (my ex buick 3800 in 2014) but now there was only sensor.

I ordered it about 2month ago and i have it.


Top
 Profile  
 
PostPosted: Wed Mar 14, 2018 5:39 pm 
Offline
Posts like a Northstar
Posts like a Northstar

Joined: Sun Aug 22, 2010 11:11 pm
Posts: 1813
Location: Ontario, Canada
Year and Trim: 2000 Bonniville SSEi L67
check the sensor for signals again

_________________
poverty forces one to do unorthodox things

2000 SSEi
past rides:
1996 SSEi
1992 GTP
1987 Grand Am


Top
 Profile  
 
PostPosted: Thu Mar 15, 2018 5:23 am 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
I did the multimeter dc test on 3x and 18x wires.

Both wires had 9volts. I had bad socket so i didnt turn crank full turn.

3x was 9v all time but i think i didnt turn engine enought to get it 0 point.

18x gived 9 to 0 when i turned engine even little.

Crank sensor plug off, it gived 9 volts both wires (i didnt rotated engine this time).


With sensor plug of and normal start, spark was gone.

Sensor plug on spark was on all cylinders, but intermitted like before.


Top
 Profile  
 
PostPosted: Thu Mar 15, 2018 8:03 am 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
I get right socket and i rotated engine many times.

Now 3x gived 9 to 0 on off depending crank position.

But why 9 volts if guide says 5-6?


Top
 Profile  
 
PostPosted: Thu Mar 15, 2018 10:43 am 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
Compression test was fine. I start engine without plugs anf injectors plugged off. It throwed fuel in firewall.



I did that a while, then i installed 100miles driven dry plugs.

It said hyrsk hyrsk couple times but no start. Same problem that has been whole time.


Top
 Profile  
 
PostPosted: Thu Mar 15, 2018 12:10 pm 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
Got it run. I think its coolant sensor.


Top
 Profile  
 
PostPosted: Fri Mar 16, 2018 2:54 pm 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
Is there some relearn or adjust process for iac?


Top
 Profile  
 
PostPosted: Fri Mar 16, 2018 3:37 pm 
Offline
Posts like a Northstar
Posts like a Northstar

Joined: Sun Aug 22, 2010 11:11 pm
Posts: 1813
Location: Ontario, Canada
Year and Trim: 2000 Bonniville SSEi L67
try starting with the old iac to see what happens

_________________
poverty forces one to do unorthodox things

2000 SSEi
past rides:
1996 SSEi
1992 GTP
1987 Grand Am


Top
 Profile  
 
PostPosted: Fri Mar 16, 2018 3:48 pm 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
I have old iac. I dont have another iac.

Car starts fine but stalls. When i start with gas pedal then it keeps idle but it humbs often than early.

And d on it pulls faster than before.


I think engine was full of fuel and when i taked plugs of and run it with start (injectors plugged of) fuel went out and new icm/coil worked.


But idle is not good.


Top
 Profile  
 
PostPosted: Wed Mar 21, 2018 5:30 am 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
Started good and immediatelly after 4 days pause.

Idle is high and D position it goes about 30mph without touching gas pedal :)

Vacuum leak?


Top
 Profile  
 
PostPosted: Thu Mar 22, 2018 5:38 pm 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
Is it normal that when i start warm/hot engine, rpm is 1500 about nano second and then drops 700rpm?


Top
 Profile  
 
PostPosted: Fri Mar 23, 2018 6:36 am 
Offline
Posts like a Northstar
Posts like a Northstar

Joined: Sun Aug 22, 2010 11:11 pm
Posts: 1813
Location: Ontario, Canada
Year and Trim: 2000 Bonniville SSEi L67
with high idle, I would check the iac and maf

_________________
poverty forces one to do unorthodox things

2000 SSEi
past rides:
1996 SSEi
1992 GTP
1987 Grand Am


Top
 Profile  
 
PostPosted: Fri Mar 23, 2018 9:26 am 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
So normal warm/hot engine starts example 700rpm and stays here? Not even nano second higher rpm?


Top
 Profile  
 
PostPosted: Fri Mar 23, 2018 2:15 pm 
Offline
SSEi Member
SSEi Member

Joined: Mon Feb 10, 2014 5:36 pm
Posts: 190
Year and Trim: 3800 1990
Hot engine idle humbs but if you drive and then go park its ok and steady.

1500rpm stumble is back too. Oh boy.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 113 posts ]  Go to page Previous  1, 2, 3, 4, 5, 6  Next

All times are UTC - 5 hours [ DST ]


Related topics
 Topics   Author   Replies   Views   Last post 
There are no new unread posts for this topic. 1989 Bonnevelle stalling at idle - MAF Code 34

89OldsRocket

7

2574

Sun Nov 27, 2016 1:31 pm

redfury View the latest post

There are no new unread posts for this topic. '90 SSE Hesitation

tomp

3

1754

Wed Apr 10, 2013 8:30 am

tomp View the latest post

There are no new unread posts for this topic. 1989 ABS

MattStrike

4

2833

Fri Apr 26, 2013 8:15 am

SSEBonne4evr View the latest post

There are no new unread posts for this topic. 1991 Bonneville Runs Rough, Stalls, Hesitation

jmuse2482

6

3551

Wed Dec 14, 2011 9:29 pm

jmuse2482 View the latest post

There are no new unread posts for this topic. 1989 LeSabre LN3 MAF trouble...

turbokinetic

7

3137

Sun Mar 29, 2015 6:55 pm

turbokinetic View the latest post

 


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group


phpBB SEO