so my rear driver side turn signal no longer works. Every other light works except that one....no juice at all...any help is appreciated!!

_________________

Back on deck with a 94 SSEi... 294K and counting!

I had a similar problem on my '92 SSE. It was more than one thing. It was the filament in the bulb and the wiring harness was pulled so tight it was going open. I replaced the bulb and relieved the stress on the wiring harness and to date have had no more problems. You could also have corrosion on/in the lamp socket, the wiring may be damaged, or a problem with a connector. Good luck and hope it is easy to fix. Also user 00Beast may have more insight. 8^)

_________________
In Memory of Brad - 1/21/1977 .. 10/23/2013 ...... Aaron - 1977 .. 2017 .....
2017 Hyundai Santa Fe Sport ..... 1992 Bonneville SSE 1SB 170 HP L27 4T60E retired/sold to MattStrike ..... 2005 Bonneville SE 1SC 205 HP L36 4T65E - retired/salvage yard ..... PBCF user 2321

Check your lamp sockets carefully, and probe the wires through the insulation. Corrosion is common. I MAY have a replacement socket for you to splice in if you need it.

I can darn near throw it to you from here.

_________________

Click here for mod list for both cars
93 SSEi, 95 SLE (supercharged) 97 Buick LeSabre Limited
PontiacDad at WCBF '04: Cruise control? That's like surrendering!
Comprehensive guide to troubleshooting, rebuilding, and modifying Eaton Superchargers

Ive actually cut the wires to splice in a new socket and tried testing the bare wire with a test light and no juice is making it through that one wire.

_________________

Back on deck with a 94 SSEi... 294K and counting!

Is there a central location the rear wires originate from so I can check the source?

_________________

Back on deck with a 94 SSEi... 294K and counting!

Can you get a wiring schematic? It will tell you where things are. I don't like anything except the Helms, but the Haynes Manual Chapter 12 might help.

So after a closer examination of the connectors. The lead that goes to the blinker was broken @ the brass connector. Spliced the green wire to the yellow wire direct, bypassing the connector, and I'm back in business

_________________

Back on deck with a 94 SSEi... 294K and counting!